Before & After Gallery - Bramwell Garage Doors Marietta

Garage Door Before & After in Marietta, GA

Any contractor can tell you they do clean work. Seeing it is different. The gallery below shows real job scenarios we handle across Marietta, from sagging doors on Powder Springs Street to rusted panels in East Cobb. These are the transformations homeowners actually call about. Photos are being added as our crews wrap projects, so check back. The captions tell you exactly what changed.

Call (912) 520-4208

Recent Transformations

Torsion Spring Failure on a Two-Car Door

BeforeAfter

The problem: a torsion spring, the heavy coil mounted above the door that handles most of the lifting weight, snapped around 6:40 on a Tuesday morning. The door was stuck half-open with one side sagging a good four inches. We replaced both springs, rebalanced the door, and had the homeowner’s car out before she finished her second cup of coffee. The after shot shows the door sitting level and lifting with one hand.

Steel Panel Replacement After a Tailgate Mishap

BeforeAfter

The problem: a teenage driver backed into the bottom two panels hard enough to bow the track. You could see daylight through the middle of the door. We straightened the track, replaced both damaged panels with color-matched steel, and checked every hinge for stress. The result looks like it never happened, and the door runs quieter than it did before the hit.

Opener Motor Burnout on a 2013 LiftMaster

BeforeAfter

The problem: a 12-year-old LiftMaster chain-drive finally gave out. The motor hummed, the door didn’t move, and the homeowner had been parking in the driveway for a week. We pulled the old unit, installed a new belt-drive LiftMaster with battery backup, and reprogrammed the keypad and both remotes. The after shot shows a clean ceiling mount and a door that opens at conversation volume instead of a rattling chain.

Full Door Replacement on a 1998 Wooden Door

The problem: a 25-year-old wooden door was rotting along the bottom panel and the paint had peeled down to bare grain. Georgia humidity had done its work. We measured the opening, ordered a new insulated steel door with a row of frosted windows, and had it installed in a morning. The temperature difference inside that garage is noticeable in July, and the street appeal doesn’t hurt either.

Roller and Cable Failure on a Wayne Dalton Door

The problem: a nylon roller disintegrated under load, which threw the door off track and frayed the cable against the rail. The door was grinding and shaking every time it moved. We replaced all rollers with sealed-bearing nylon, installed a new cable set, and checked the drum alignment on both sides. The after shot shows the door gliding straight up the track with no wobble and half the noise.

Hinge and Section Alignment After Years of Strain

The problem: a single-car steel door had been nursing failing hinges for years. Sections were misaligned by a quarter inch at the center seam, and the door would bind halfway up. We installed heavy-duty hinges at all four seams, corrected the section alignment, and re-tensioned the springs to match the corrected weight. The door now clears the opening without a single pop or scrape, and the homeowner said it sounds like a different door entirely.

Want Results Like These?

If your door looks like the “before” photos above, call us. We’ll send a background-checked, uniformed technician who gives you a written price before any work starts. Every repair carries the 365-Day Done Right Promise in writing. Call (912) 520-4208 and a live person answers, day or night.

Written by Marcus Ellery, Owner at Bramwell Garage Doors Marietta, serving Marietta and surrounding Cobb County since 2001.