Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterSpring Repair in Marietta, GA
Garage door spring repair in Marietta typically costs between $150 and $280 for most torsion spring replacements, parts and labor included, and a skilled technician can usually complete the job the same day you call. Broken springs are the most common reason homeowners need Garage Door Repair services in our area, especially in neighborhoods like East Cobb, Indian Hills, and Whitlock Heights where homes built in the 1980s and 1990s are hitting the end of their original spring lifecycle. If your door refuses to open or you heard a loud bang from the garage, call Bramwell Garage Doors Marietta at (912) 520-4208 and we’ll give you a written price before any work begins.
Our spring repair service is part of the broader Garage Door Repair in Marietta work we do across Cobb County. Marcus Ellery and the team at Bramwell Garage Doors Marietta have been replacing and repairing garage door springs since we opened our doors under the Kingswell standard, and we’ve learned that this specific repair is where homeowners get burned most often. A spring that’s sized wrong, installed sloppily, or left unbalanced will fail again within months. We don’t do that. We install the right spring for your door’s weight and cycle rating, balance the door, and back the work in writing. That’s the home standard we hold ourselves to on every single job.
When You Need Spring Repair
Here’s what homeowners in Marietta actually experience when a spring fails. If any of these sound familiar, call us before the door gets stuck in the down position with your car trapped inside:
- You heard a loud bang from the garage. A torsion spring breaking under tension sounds like a gunshot or a car backfiring. If you heard it, check the spring mounted on the barrel above the door. You’ll likely see a visible gap in the coil.
- The door won’t lift at all, or lifts only a few inches. A broken spring means the opener motor is trying to dead-lift a 150 to 250 pound door by itself. It can’t, and forcing it will burn out your opener.
- The door feels much heavier than it should. Disconnect the opener and lift manually. A properly balanced door should feel like it weighs about 10 pounds. If it feels like 100, a spring has failed or lost tension.
- The door slams down instead of closing gently. Springs counterbalance the door’s weight during closing too. When one side fails, the door can drop hard and fast, which puts stress on the panels, hinges, and cables.
- The door is crooked when it opens or closes. In Marietta’s humid summers, uneven wear on springs can cause one side to stretch before the other. A door that hangs unevenly is a door that’s working against itself.
- Your spring is visibly stretched or has a gap in the coil. You can see this without touching anything. Walk into the garage, look up at the spring on the barrel above the door. A gap between coils on a torsion spring means failure is imminent.
One thing we see often in the spring repair trade in Marietta: people keep using the opener after one spring breaks. Don’t do that. The opener will strain, the cables can snap, and you’ll turn a $200 spring replacement into a much bigger bill that may also require Cable Repair. Call us instead. We answer the phone 24/7, and a live person will pick up. No voicemail maze.
Our Spring Repair Process
Here’s exactly how a spring repair works when you call Bramwell Garage Doors Marietta. This is the Kingswell Way, and we follow it on every job without exception:
- You call (912) 520-4208, and a live person picks up. No phone tree, no “leave a message and we’ll get back to you.” We’ll ask about your door type, the spring you have, and when you need us there. We’ll give you a real arrival window, and we’ll hit it.
- Our technician arrives in a Bramwell uniform. You’ll know exactly who’s pulling into the driveway. All our technicians are background-checked, and they’ll introduce themselves and explain what they’re seeing before touching anything.
- We inspect the full door, not just the spring. A broken spring is rarely the only thing wrong. We check the cables, drums, rollers, hinges, and the opener’s limit switch travel, so we can replace what’s actually worn and leave the rest alone.
- We present a written price before any work starts. This is non-negotiable. The number on the invoice will match the number we showed you on the quote. Most torsion spring replacements in Marietta run $150 to $280, parts and labor included, but the exact price depends on your door’s weight, spring size, and whether you need one spring or both replaced.
- We install the correct spring and balance the door. We size the spring to your door’s exact weight and expected cycle count, then we wind it to spec and fine-tune the balance. We replace both springs when one fails on a two-spring door because the other spring is at the same point in its lifecycle and will break soon anyway, probably in the next 60 days.
- We test the full cycle, clean the job site, and hand you the written guarantee. The 365-Day Done Right Promise goes in writing on every repair. If the spring or any part of the repair fails within the guarantee period, we come back and fix it at no charge. No fine print games.
Spring Repair Pricing in Marietta
Let’s talk about How Much Does Garage Door Repair Cost? (2026 Price Guide) - Marietta, GA, because we know that’s what you actually want to know before you pick up the phone. Here’s what spring repair costs in the Marietta market based on what we see day in and day out:
| Service | Typical Price Range | What’s Included |
|---|---|---|
| Single torsion spring replacement | $150 – $280 | Spring, labor, balance adjustment, written guarantee |
| Double torsion spring replacement | $220 – $400 | Both springs, labor, balance adjustment, written guarantee |
| Extension spring replacement (both sides) | $140 – $240 | Both springs, safety cable check, labor, written guarantee |
| Spring inspection and balance test | Free with any repair | Full spring, cable, and balance evaluation |
What affects the price? The weight of your door is the biggest factor. A lightweight aluminum door in a Powder Springs townhome takes a smaller spring than a heavy wood door in a Whitlock Avenue bungalow. The brand of door matters less than people think, but we service all the major ones, including Chamberlain, Genie, Clopay, and Amarr, and we stock springs compatible with each. Whether you need one spring or two also moves the number.
Every quote we give is a written price before any work starts. You’ll see the exact number, you’ll approve it, and that’s the number you pay. The 365-Day Done Right Promise is written right into that quote. If the repair fails within a year, we come back and correct it at no charge. That’s not a verbal handshake. It’s on paper.
Is It Cheaper to Repair or Replace the Springs?
Repairing a spring, in the sense of welding or re-tensioning a broken one, isn’t something we recommend, and it’s not something a reputable company offers. The steel in a broken torsion spring has already fatigued past its usable life. You replace a broken spring, you don’t fix it. The real question is whether to replace one spring or both. If your door has two springs and one breaks, we recommend replacing both. The surviving spring has the same number of cycles on it as the broken one, and it will likely fail within 60 to 90 days. Replacing both at once costs more up front but saves you a second trip fee and a second morning of being stuck. In Marietta’s climate, where garages get hot and humid from June through September, we see spring failures cluster, so this is a real consideration.
How Long Do Garage Door Springs Last in Marietta?
Most springs are rated for 10,000 cycles, which translates to roughly 7 to 9 years for a typical Marietta household that opens and closes the door three or four times a day. Heat and humidity, which Cobb County has plenty of, accelerate metal fatigue. So do infrequent use, which allows rust to form on the coil, and heavy doors that put more load on the spring than it’s rated for. If your spring is 7 years old or older and you’re noticing the door feeling heavy or the opener laboring, call us at (912) 520-4208 for a free spring inspection and balance test. We’ll tell you honestly whether the spring has life left in it or whether replacement now saves you a breakdown later.
FAQs – Spring Repair
How much does garage door spring repair cost in Marietta?
Most torsion spring replacements in Marietta run $150 to $280 for a single spring, parts and labor included, and $220 to $400 for a double spring replacement. The exact number depends on your door’s weight, spring size, and whether you have one spring or two. Bramwell Garage Doors Marietta gives you a written price before any work starts, so you’ll know the number before you approve anything. Call (912) 520-4208 for a free estimate, and we’ll give you an exact quote based on your door.
Can you fix my garage door spring today?
Yes, in most cases we can have a technician at your Marietta home the same day you call. We answer the phone 24/7, and we’ll give you a real arrival window when you book, not a vague “sometime between 8 and 5.” Spring repair is one of our fastest services because we carry the common spring sizes for Marietta’s most popular door brands, including Chamberlain, Genie, and Clopay, on our trucks. Call (912) 520-4208 to check today’s availability.
Why did both my garage door springs break at the same time?
On a two-spring door, both springs are installed at the same time and go through the same number of open-and-close cycles. They almost always fail within weeks or months of each other, which is why we recommend replacing both when one breaks. The second spring is at the same fatigue point as the first, and replacing only the broken one means you’ll likely be calling again before the season changes. That’s why our quote for a two-spring door includes both springs, not just the one that snapped.
Is it dangerous to try to replace a garage door spring myself?
Yes, and we strongly recommend against it. Torsion springs are wound under high tension, enough force to seriously injure or kill if the winding bar slips. Extension springs stretch under load and can become projectiles if a cable snaps. Spring replacement requires specific tools, precise winding, and experience with door balance. If you’re seeing signs of spring failure, call Bramwell Garage Doors Marietta at (912) 520-4208. A trained, background-checked technician will handle it safely, and the repair is covered by the 365-Day Done Right Promise in writing.
Spring Repair You Can Count On – Call Bramwell Garage Doors Marietta
If your garage door spring has failed, you’re not just stuck; you’re potentially locked out of your own house or stuck with a car trapped inside. We know how much that disrupts a morning in Marietta. That’s why we answer the phone 24/7 with a live person, why we give you a real arrival window, and why we put the price and the guarantee in writing before any work starts. Marcus Ellery and the team at Bramwell Garage Doors Marietta have been doing this work under the Kingswell standard since 2001, and we back every spring repair with the 365-Day Done Right Promise. If it’s not done right, we make it right, at no charge, in writing. Call (912) 520-4208 now and get your door working again today.
Written by Marcus Ellery, Owner at Bramwell Garage Doors Marietta, serving Marietta.